Module

UDMII Plus LP 180D (Type D) (H)

Module

UDMII Plus LP 180D (Type D) (H)

Built-in hardware ECC
Global wear-leveling
Flash bad-block management
S.M.A.R.T.
connector designed with latch locking

Introduction

Apacer’s USB-Disk Module (UDM) II Plus is a USB2.0 high speed flash storage designed to replace a conventional IDE hard disk drive. UDMII Plus LP 180D coming with both w/o houing and with house can be plugged into a standard Embedded USB connector commonly found in desktops, portable PC systems and industrial PC systems. This product is well suited for embedded flash storage applications offering new and expanded functionality as well as more cost-effective designs, better performance and increased reliability.

Spec

Model

UDMII Plus LP 180D (Type D) (H)
Interface

USB 2.0
Connector

10-pin USB (2 x 5 header)
Form Factor

USB Disk Module
NAND Flash Type

SLC
Capacity

256MB~32GB
Sequential Read Performance (MB/sec)

Up to 34
Sequential Write Performance (MB/sec)

Up to 22
ECC Engine

Built-in 24-bit per 1K bytes BCH ECC
Standard Operating Temperature (°C )

0 ~ + 70
Extended Operating Temperature(°C )

-40 ~ + 85
Storage Temperature(°C )

-40 ~ + 100
Housing

Optional
H/W Write Protect

Optional
Shock

Half sine wave 50G, 6 axes, 18 times
(IEC 68-2-27, non-operating)
Vibration

Sine wave 10 Hz to 500 Hz, 50 m/s2, 3 axes
(IEC 68-2-6, non-operating)
Operating Voltage

5.0 V ± 5%
Power Consumption

Active mode: 181 mA; Idle mode: 68 mA
Dimension (L x W x H )

Without Housing: 33.65 x 24.00 x 7.00 mm
With Housing: 35.70 x 28.10 x 7.20 mm
MTBF (hours)

>2,000,000